Problem with packet tracer 7.3.2.6

Data that travels over the air and how to protect (or decipher) it

Problem with packet tracer 7.3.2.6

Post by ghostheadx2 on Wed Jan 18, 2017 9:20 pm
([msg=93293]see Problem with packet tracer 7.3.2.6[/msg])

I'm trying very hard to fix the problem with the network presented in this packet tracer. The problem is I keep trying to bring up interfaces and assign IPs to the interfaces. I want to get devices to connect to the VLAN but I'm having a very hard time doing so. Is the problem that I need to make multiple VLANs? I'm clearly doing something wrong and getting stuck.

Is there anything I can review or lookup that might lead to me getting the answer? Am I over-complicating it? What is it I can do? I have the answers to my questions so far in a notepad document. Should I send it to you?

I've been trying this for two days and haven't gotten anywhere.

Here is my inputs and outputs so to speak:

R1
Code: Select all
R1#show ip interface brief
Interface              IP-Address      OK? Method Status                Protocol
GigabitEthernet0/0     unassigned      YES unset  up                    up
GigabitEthernet0/1     10.10.1.97      YES manual up                    up
Serial0/0/0            unassigned      YES unset  down                  down
Serial0/0/1            10.10.1.6       YES manual up                    up
Vlan1                  unassigned      YES unset  up                    down


R2
Code: Select all
R2#show ip interface brief
Interface              IP-Address      OK? Method Status                Protocol
GigabitEthernet0/0     10.10.1.21      YES manual up                    down
GigabitEthernet0/1     10.10.1.14      YES manual up                    down
Serial0/0/0            10.10.1.2       YES manual up                    up
Serial0/0/1            10.10.1.9       YES manual up                    up
Vlan1                  11.0.0.2        YES manual up                   


R3
Code: Select all
R3#show ip interface brief
Interface              IP-Address      OK? Method Status                Protocol
GigabitEthernet0/0     11.0.2.1        YES manual up                    up
GigabitEthernet0/1     10.10.1.17      YES manual up                    up
Serial0/0/0            12.0.0.1        YES manual down                  down
Serial0/0/1            10.10.1.10      YES manual up                    up
Vlan1                  11.0.1.1        YES manual up                    down


I also tried looking at modifying the interfaces of the switches, but I don't see what I can do. I first thought for a split second that making the vlan in S3 the same IP as the vlan in R3 would help bring the interface up, but no cigar:

S3
Code: Select all
Switch5(config)#interface vlan1
Switch5(config-if)#ip address 11.0.1.1 255.255.255.0
Switch5(config-if)#no shutdown
Switch5(config-if)#exit


It didn't make a difference in R3. I looked at this forum thread and didn't get much luck, simply because I probably interpreted the solution wrong:

https://supportforums.cisco.com/discuss ... ies-switch

Can anyone help with this please? Thanks.
ghostheadx2
Contributor
Contributor
 
Posts: 728
Joined: Wed Nov 19, 2014 1:19 am
Blog: View Blog (0)


Return to Networking

Who is online

Users browsing this forum: No registered users and 0 guests